Rusty Lee 3/4 Width Rock & Roll Bed
If fitted in a T5/T6 this bed has been in vehicle M1 (Crash) tested.
The bed is made from box section and all the hinge plates are CNC laser cut. The bed sits over the wheel arch in the rear of front engine vans and fixes through the floor with high tensile bolts.
The bed operates on heavy duty ball bearing slides so pulls from seat to bed position with ease, the front legs also sit 5mm higher than your floor, so you don’t get any scuff marks on your nice new floor when pulling into bed position. The bed locks off into seat position with two heavy duty quick release spring loaded pins. It sits on rubber buffers, so no rattling when you’re on the move.
The frame comes fully powder coated and operates from seat to bed mode in just a few seconds. This bed is designed to have the upholstery attached to the frame and not made with butt hinges like others out there, so your covers won’t go flying off when you need to brake hard. The gas strut will make putting the bed back to seat effortlessly.
- Width 1090mm (custom widths and size available to order)
- Length in bed position 1880mm
- Fully powder coated in black (other colours available to order)
- Designed to take 3 inch foam
- Storage space available underneath the bed
Here is a short video of the operation of the Rusty Lee bed: https://www.youtube.com/watch?v=373x4E2H8fU